If you download the PDF file you will see pictures or our prototype collar.  For insulated wires these need to be made with no insert.  The collar will be electrically invisible and present no more that .01 MFD to the circuit.  The collars must all be tied to #6 copper wire to ground rods.

Collars for un-insulated wires must have a glass insert that will allow them to be electrically invisible with no more that .01 MFD reaction.  The collars over un-insulated wire will have to have a glass insert and be properly fitted for the working voltage of the bare wire.  Thus a collar for a 14,200 volt neighborhood distribution system will be different from 65KVA transmission lines.  If you have your parts supplier contact us we can give them sources.  No money to us up front.  Dr. Kreig is working on manufacturing sources.
The challenge is that there are all sorts of different grids and working voltages.  Thus collars will have to be made to go over your un-insulated and insulated wires.  The DC sensor is another item you and your engineers and suppliers can get done in time.

We will do all we can to help you.  Without the Grid people will die.  We do not want that.

Cars and trucks made after 1988 have computers that will burn up.  Only older vehicles without computers will run.  Old school buses, diesels, etc. Remember the Carnival Cruse Line Splendora was dead in the water after an EMP pulse hit the ship.  Airplanes could fall out of the sky when the storm hits.  Only the Russians use all vacuum tube avionics.